Widget
For this project you need to create the widget in Inventor or Fusion 360. Once that's done you need to create the tool paths for the bottom of the widget and the round top part of the widget. Then export the file and bring it to the CNC mill. Then you copy the file onto the mill and move the bit to just above the corner of the foam piece. Then once its set zero the coordinates and hit reset just to be safe. Then click start and watch it to make sure it works properly.
|
The CNC Mill project wasn't very hard at all. All you had to do was have a correct file and setup the machine then let it go. It only took a few minutes for each Widget to cut out so everyone could get it done.