Maze
The first step in making the maze is building it in Inventor. You could also create it in Fusion 360 if you know how. Once you've done that you upload your file into Fusion 360 and setup a tool path for the paths in the maze as well as the outside edges of your maze. Once you've simulated the path and it works without errors you can post the G-code. Then you can bring it down to your machine.
|
That's it. The maze is done. Once its all finished cutting out you can grab it off of the machine.
In this project I learned that Fusion 360 is a pretty challenging software. Once you've got it down then you understand it. Unfortunately for me my maze didn't cut out correctly when I did it. It started cutting out an inch above where the foam was (yes I zeroed it with the bit on the correct spot touching the foam.)